Application of Photocatalytic Process Using UV/TiO2 for Degradation of Cefepime: A Comparison between Photocatalytic and Photolytic
نویسندگان
1
2
3 سازمان پژوهشهای علمی و صنعتی ایران
4
5 دانشگاه پیام نور
doi
10.30492/ijcce.2021.75125.2807چکیده
Cephalosporin is a group of β-lactam antibiotics that has a wide antibacterial ability, so its therapeutic use is high. Although much research has been conducted about the fate of antibiotics in an aquatic environment, little investigation has been done about the removal of cephalosporin. In this study, Cefepime, a fourth-generation cephalosporin antibiotic was selected and different tests such as UV/TiO 2 , UV, TiO 2 under darkness, and TiO 2 under sunlight were applied to determine whether these methods are effective ways to remove Cefepime from aqueous solutions or not. Different amounts of catalyst and different pHs were used as effective parameters on degradation efficiency and were optimized. The Cefepime removal was measured by HPLC. The mobile phase was comprised of 10:90 Acetonitrile: water with a flow rate of 1 mL/min. The detected wavelength was 212 nm. Maximum removal efficiency (92.9%) for 20 mg/L Cefepime in neutral pH and catalyst dose of 70 mg/L after 120 min irradiation was observed. At the same conditions, the degradation efficiencies for UV, TiO 2 under sunlight, and TiO 2 under darkness were determined 77.65%, 53.24%, and 15.12% respectively. Also, the reaction rate constant was increased from 0.0054 to 0.0279 (1/min) for photolysis and photocatalysis, respectively. This work was economically compared with photolysis and the result showed that the E EO for the UV/TiO 2 process was five times lower than UV processes.UV/TiO 2 process could be an efficient method to successfully remove the Cefepime antibiotic from aqueous solutions.