Use of nanoscale zero-valent iron to improve the shear strength parameters of gas oil contaminated clay
نویسندگان
1 Engineering Geology Division, Department of Geology, Faculty of Basic Sciences, Tarbiat Modares University
2 Department of Chemistry, Faculty of Basic Sciences, Tarbiat Modares University, Iran
3 Engineering Geology Division, Department of Geology, Faculty of Basic Sciences, Tarbiat Modares University, Iran
4 Engineering Geology Division, Department of Geology, Faculty of Basic Sciences, Tarbiat Modares University
doi
10.22059/jgeope.2015.56093چکیده
In recent years, the nanoscale zero-valent iron (NZVI) particles have been used successfully for the degradation of hydrocarboncompounds and remediation of other pollutants. Nevertheless, as far as we know, there is no specific study on the improvement of thegeotechnical properties of contaminated soils with hydrocarbon compounds by NZVI. This study used NZVI particles to remove gasoil in a clayey soil and determined the effects of NZVI on Atterberg limits, compaction properties, and shear strength parameters of thesoil. In order to determine the optimal reaction time and NZVI dosage, the total organic carbon (TOC) of a contaminated soil with 9%of gas oil was measured. The experimental data showed that the optimum reaction time and NZVI dosage were 24 days and 5%,respectively. Then, the contaminated samples were prepared by mixing the soil with gas oil in the amount of 0, 3, 6, and 9% by dryweight. The results showed a decrease in the friction angle (φ) and an increase in the cohesion (C). Maximum dry density and optimummoisture content of the soil decreased due to the contamination. In addition, an increase in liquid limit (LL) and plastic limit (PL) wereobserved. Finally, all contaminated specimens were mixed with 5% of NZVI. After 24 days, an increase was seen in the friction angle,cohesion, maximum dry density, and optimum water content. LL and PL of the soil decreased after the treatment