Fabrication of a Sulfite Biosensor by the Use of Conducting Polymer
نویسندگان
1 Department of Biomedical Engineering, Amirkabir University of Technology, P.O. Box 15875-4413 Tehran, I.R. IRAN
2 Department of Biomedical Engineering, Amirkabir University of Technology, P.O. Box 15875-4413 Tehran, I.R. IRAN
3 Department of Chemical Engineering, Amirkabir University of Technology, P.O. Box 15874-4413 Tehran, I.R. IRAN
4 Department of Biomedical Engineering, Amirkabir University of Technology, P.O. Box 15875-4413 Tehran, I.R. IRAN
doi
10.30492/ijcce.2008.7132چکیده
In this research, an enzyme modified electrode has been produced during the electropolymerization of aniline through incorporation of sulfite oxidase into a conducting polymer. Then the bioelectrochemical response of resulted sulfite biosensor was investigated at different experimental conditions. Study of the stability of the resulted sulfite biosensor revealed that formation of a passive film on the aluminum surface causes improved stability of the electroactive films formed on the electrode surface. The bioelectrochemical response of the enzyme-modified electrode as a sulfite biosensor was investigated at different experimental conditions. The optimum pH and temperature were 8.5 and 35°C, respectively. The apparent Michaelis-Menten constant and the activation energy of the enzyme catalyzed reaction were calculated.
