Experimental Investigation on Heat Transfer of Silver-Oil Nanofluid in Concentric Annular Tube
نویسندگان
1 Department of Mechanical Engineering, College of Engineering Takestan branch, Islamic Azad University, Talestan, I.R. Iran
2 Mechanical Engineering Department, Islamic Azad University of Behbahan, Behbahan, I.R. Iran
3 Department of Mechanical Engineering, College of Engineering Takestan branch, Islamic Azad University, Talestan, I.R. Iran
4 Aerospace Engineering Department, University of K. N. Toosi Technology, Tehran I.R. Iran
doi
10.7508/tpnms.2015.02.006چکیده
In order to examine the laminar convective heat transfer of nanofluid, experiments carried out using silver-oil nanofluid in a concentric annulus with outer constant heat flux as boundary condition. Silver-oil nanofluid prepared by Electrical Explosion of Wire technique and observed no nanoparticles agglomeration during nanofluid preparation process and carried out experiments. The average size of particles established to 20 nm. Nanofluids with various particle weight fractions of 0.12%wt., 0.36%wt. and 0.72%wt. were employed. The nanofluid flowing between the tubes is heated by an electrical heating coil wrapped around it. The effects of different parameters such as flow Reynolds number, diameter ratio and nanofluid particle concentration on heat transfer coefficient are studied. Results show that, heat transfer coefficient and Nusselt number increased by using naanofluid instead of pure oil. Maximum enhancement of heat transfer coefficient occurs in 0.72% wt. also results indicate that heat transfer coefficient increase slightly by using low wt. concentration of nanofluids.
