Activation of Fluorohydride by Various Chemical Additives for the Production of Construction Materials Based on It
نویسندگان
1 Research Center Surface Engineering and Tribology, Sarsen Amanzholov East Kazakhstan University, Ust-Kamenogorsk 070000, KAZAKHSTAN
2 Institute of Composite Materials, Ust-Kamenogorsk, 070000, KAZAKHSTAN
3 Plasma Science LLP, Ust-Kamenogorsk 070000, KAZAKHSTAN
4 Plasma Science LLP, Ust-Kamenogorsk 070000, KAZAKHSTAN
5 Research Center Surface Engineering and Tribology, Sarsen Amanzholov East Kazakhstan University, Ust-Kamenogorsk 070000, KAZAKHSTAN
doi
10.30492/ijcce.2024.2028014.6582چکیده
In this study, we investigated the effects of various additives on the properties of fluorine hydrite binders, created by neutralizing acidic waste from hydrofluoric acid production. Our objectives included determining how the technological properties of anhydrite binders change with different additive amounts, identifying the optimal binder composition, developing mathematical models of the involved processes, and conducting statistical analysis through experimental design and mathematical planning. Particle-size analysis was performed using dynamic light scattering with a Fritsch Analysette-22, and the samples' phase composition was examined using an X'PertPro X-ray diffractometer (Philips Corporation, Netherlands). Calculations were performed using STATISTICA software. The studies showed that the setting speed and strength of products based on anhydrite binder are primarily influenced by the water temperature and amount used for mixing, assuming optimal binder dispersity. The strength of samples made from neutralized waste ranged from 0.5 to 1.2 MPa, while the strength of samples based on activated anhydrite binder ranged from 5.3 to 10.7 MPa, meeting the requirements for board production.
